Lifting Device Engineering

Our Professional Engineer with over 20 years’ experience in lifting device structural engineering has the ability to provide capacity ratings for any type of lifting or support device.

Technical Loadarm specializes in reverse engineering of existing equipment, and providing capacity ratings so that you are compliant. If drawings are provided, our Engineer can provide the capacity rating right on the drawing, and stamp with his seal

If an item has been modified, a load test may be performed as verification of a lifting device’s capacity. Our load testing procedure consists of four segments: The pre-inspection, load test, post inspection and Engineer’s report.

Our Technician will perform the pre-inspection to insure your equipment is capable of lifting the load without failure. If the equipment is deemed “certified”, the Technician will perform the load test. After the load is released, the lifting device is thoroughly inspected, for deformation, cracks or other defects, utilizing magnetic particle inspection. A load test report is prepared, signed and stamped by our Engineer.

A Pre-start Health and Safety Review (PSR) is a safety audit of a modified or newly designed piece of equipment. Our goal is to identify any safety concerns that may lead to workplace injury. We can also identify any deficiencies and provide the necessary advice needed to deem the equipment “certified” and therefore keeping your equipment in compliance with the Ministry of Labour.